![]() Sample weekday schedule, obtained from The airports involved are: These are the commercial flight departures for the state of Maine. Make sure it goes into the Departures folder or it will not work. X-Plane 10\ClassicJetSimUtils\WorldTraffic\GroundRoutes\Departures Inside the GroundRoutes folder will be a folder named "KMHT." X-plane 10\ClassicJetSimUtils\WorldTraffic\RouteFiles Two folders, "GroundRoutes" and "RouteFiles." Inside the RouteFiles folder will be folders When you unzip the file, you will have a folder called "New Hampshire." Inside of this will be KLEB did not have any ramp areasĪnd I didn't include ground routes for this, since the planes had nowhere to come from. If you are using custom sceneryįor this airport, I can't promise it will work correctly. The Ground Route is based on the default scenery. However, at the end of each file I have noted what the aircraft should be The larger planes all use 747s, and the smaller prop traffic uses Columbias. KMHT - Manchester-Boston Regional AirportĪt the moment, we are limited in the choices of aircraft in WorldTraffic. They areīased on a sample weekday schedule, obtained from The airports involved are: These are the commercial flight departures for the state of New Hampshire. NEW HAMPSHIRE - WORLDFLIGHT FLIGHTPLANS AND GROUND ROUTES ![]() I also recommend disabling generating ground routes on resync in the Flight Setup window of WT3 so that flying around won't prompt the user to generate new routes for the nearest airport (don't forget to generate routes manually or enabling the setting back if using an actual WT3 flight plan with a destination). Minimum altitude AGL for refreshes (in feet). Recommended value of at least 5 otherwise WT will not have the time to initiallize. Set this to true if you want WT to resync every time a flight is started. Refresh at every flight startup (boolean true/false). The following settings can be customized inside the lua script by editing the beginning of the script via any text/code editor. Place WT3 a inside the D:\X-Plane 11\Resources\plugins\FlyWithLua\Scripts folder. Installation is similar to any FlyWithLua script. To use this script, you need to have FlyWithLua installed. I don't recommend using this if you are using the WT3 ATC as it will reset the flight for ATC on each resync. The script also has a minimum altitude setting so that the resync will not happen when in phases of flight such as the short final. Although it can also be used for flying bigger planes under a typical WT3 flight route, I don't recommend it for heavily populated airports since those can take a while to resync and that could be a problem mid flight. This script is mostly made for VFR GA flying so that the user can fly around and not bother to always refresh traffic once it strays too far from the starting airport. This is a little lua script that resyncs WT3 traffic periodically when the user's aircraft travels a certain distance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |